1. There is no need to feed the material during debugging, but the guide screw on the guide plate must be adjusted upwards, and then the hammer of the punch press is slowly adjusted to the bottom dead center by inching. down too low, otherwise the floating rod will bend or break.
2. When starting the cross-cutting machine to work continuously, the speed adjustment screw of the feeder must be rotated clockwise, and the slider movement is slightly slower, so that it can be seen whether the nylon gasket and the length fine-tuning screw are encountered during the reciprocating movement of the slider.
3. During the test run, the slider moves back and forth. If it only touches the nylon gasket and does not touch the length fine-tuning screw, it is because the floating rod is not lowered deeply enough, and the guide screw on the punch needs to be lowered slowly.
4. If the cross-cutting machine only touches the length fine-tuning screw and does not touch the nylon spacer when the slider moves back and forth, it is because the floating rod descends too deep, and the guide screw on the punch needs to be slowly adjusted upwards.
5. If the slider moves between the length fine-tuning screw and the nylon washer and the distance between the two sides is equal, at this time, it is necessary to rotate the speed adjustment screw in a counterclockwise direction to make the slider speed normal, and to make the slider reciprocate. Nylon spacer and spacer ring.
6. If the speed of the cross-cutting machine remains the same and the feeding distance needs to be changed from long to short, first adjust the guide screw up to reduce the descending distance of the floating rod, and then rotate the speed adjustment screw clockwise, so that the feeding can match the punching speed.
7. If the speed of the cross-cutting machine remains unchanged and the feeding distance needs to be changed from short to long, first lower the guide screw to increase the descending distance of the floating rod, and then rotate the speed adjustment screw counterclockwise, so that the feeding can match the punching speed.
