1. Before using the paper tube machinery and equipment, prepare the raw material paper bag. We cut the base paper into paper tapes of the width we need for spare use. How to determine the relationship between the width of the paper tape and the inner diameter of the paper tube? You can learn about the roll paper tape Angle and width calculation method, but here you should pay attention to the width of the first sheet of paper should be the same as the width of the belt or 1.2mm wide;
2. Apply lubricating oil to the bottom paper: The bottom paper is used as the part of the fixed mandrel that rotates to the cutting head. Since the fixed mandrel is fixed by the paper tube mechanical equipment and the paper tape needs to rotate on the surface of the mandrel, in order to reduce friction, the bottom layer is placed on the bottom paper. Apply lubricating oil inside. The editor suggests that you can break through silicone oil, vegetable oil and liquid paraffin, etc. You should pay special attention not to apply too much lubricating oil to cause the paper tape to slip, but if too little lubricating oil is applied and the wrong type of lubricating oil is used, the paper tape will be stuck on the mandrel. cannot be used on the . In order to ensure the high quality of the paper tube produced by the paper tube machinery and equipment, we should pay attention to the same entry speed of the paper tape as that of the drive belt and the correct entry angle of the paper tape;
3. Prepare the binder: In the production process of the paper tube, the second layer and all subsequent layers must use the binder (usually dry chemical paste);
4. Wiring preparation: After we connect the paper tube mechanical equipment to the three-phase power, we should let the paper tube machine perform a no-load operation test (observe whether the motor selection direction is correct), and then connect the excitation current to the clutch to let the output After the shaft and the motor rotate in the same direction, adjust the potentiometer on the adjustment controller, then the head of the paper tube mechanical equipment can start to operate normally;
5. Air pipeline preparation: If we use compressed air to cut the pipe, we need to connect the air pipe with rated air pressure.
